Use a Phillips screwdriver to hand tighten the screw from the back of the cupboard or drawer front threading the screw into the knob or pull located on the front. Frequently asked questions about kitchen hardware and cabinet pulls What are the most popular cabinet pulls The most popular cabinet pulls tend towards the sleek and modern. Drill a hole completely through the cabinet face. This will assure the pull sits flat against the cabinet face. A stud-boss is an extension of the screw mould that will be counter-sunk into the cabinet door. Some pulls that have stud-bosses will require a 1/4” hole. Use the recommended 3/16” drill bit after you’ve marked your knob or pull placement. This will assure precision placement of your knobs and pulls. For lower cabinets, knobs and pulls are often placed in the upper corners, again, for ease in accessibility. For new installation use a Hickory Hardware drill hole template with drill bit. By doing this, the functionality of your cabinet pulls is maximized. Cup and tab pulls will follow the same sizing recommendations as bar pulls however, their placement will vary. Kitchen handles should be vertical according to the general rule of thumb. A great opportunity to incorporate this strategy is to use knobs on the cabinets while using pulls on the drawers. Any drawer broader than 32 inches will require a pull longer than 12 inches. Mixing knobs and pulls on kitchen cabinets is an excellent way to add to the atmosphere of your kitchen and include some added flavor to the design. Use a tape measure to find the center of the cabinet door frame and mark with a pencil. Drawers 16-32 inches wide are best embellished with two smaller pulls 5-7 inches in length or one larger pull 9-12 inches long. As a general rule, due to soft edges, if you place two kitchen cabinet knobs and cup pulls on your kitchen cabinets, it is best that they only be used on the. Hickory Hardware supplies 8-32 x 1” screws to accommodate the standard drawer front. If a drawer front is constructed with a thicker drawer front or drawer box, additional screw length may be necessary and sold separately. The general rule is to place a knob 2 to 3 inches from the corner of the door. Home › News › How to Install Cabinet Knobs and Pulls Cabinet knobs should be installed on the side opposite the hinges.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |